Process wall chemical-resistant lining
Process-area walls take splash, mist, and spill that ordinary paint cannot survive, especially at the floor-wall junction where product puddles.
The need for process wall chemical-resistant lining
BHI Coatings performs process wall chemical-resistant lining across Alvin and the Texas Gulf Coast. Splash, mist, and spill are a daily event on a process-area wall, and ordinary paint does not survive them. The floor-wall junction is the worst spot of all, because product puddles there and wicks into the joint. Once the coating fails the wall starts absorbing chemical, and then it stains, degrades, or contaminates the area around it.
How BHI Coatings does process wall chemical-resistant lining
We prepare the wall and floor-wall junction, then apply a chemical-resistant immersion-grade system supported by the Belzona 5811 and 4311 coatings. Our crew reinforces the floor-wall corner, since puddling there is what drives the failure. The lining cures cold, so the area stays in service while the work goes on around it.
Typically applied with Belzona 5811, Belzona 4311, Belzona 1321, matched to the service conditions.
The wall carries a chemical-resistant barrier that takes splash and spill, and the floor-wall junction is sealed against standing product.
More Tank & Containment Lining applications
Bund walls spall from the inside out, exposing rebar and opening cold-joint cracks until the wall no longer holds its rated volume.
Learn more →Chemical storage tank liningsStored chemicals attack tank floors and the floor-to-shell weld, thinning steel where stagnant product settles and the old lining has worn through.
Learn more →Digester lining and repairKraft digesters carry hot sulfate-rich liquor that thins linings and corrodes every weld and access port over a single campaign.
Learn more →Evaporator, de-aerator and autoclave liningEvaporators, de-aerators, and autoclaves run hot and wet, so conventional linings break down and the shell corrodes at welds and tube zones.
Learn more →Food and beverage hygienic liningsTanks and troughs in food and beverage plants face daily caustic wash-down and hot CIP cycles that ordinary coatings cannot pass on audit.
Learn more →Potable-water tank liningInternal corrosion in drinking-water tanks and pump components forces a choice between costly replacement and a certified recoat.
Learn more →All 12 in Tank & Containment LiningThe whole capability in one place, with the work grouped.
See the capability →Contact BHI Coatings
Have equipment that needs to stay in service?
Tell us what is failing. We respond quickly, and we offer 24-hour on-call service.